Caution: this does not follow guidance for using theHandy and could result in getting pinched by theHandy down there.
I’m using theHandy along with a projector mount screwed into a small fiberboard monitor riser and two pillows on either side to keep things aligned and help silence the little noise from theHandy. The sleeve is facing me for this setup which is against what they advise but I haven’t had issues of getting pinched. I’m lying down in bed with this setup.
Amazon.com: NVRTTRR Vertically Mounted Projector Bracket Wall-Mounted Universal Ceiling Wall Projector, 1/4" Screw, Camera Bracket Mini Projector Bracket（2.36in） : Electronics ← 1/4 projector mount, it is a little loose and needs extra tightening on the ball joint
Amazon.com: Kensington 52785 SmartFit Monitor Stands, 12.25w x 2.25d x 4.75h, Black : Electronics ← Kensington desk mount with the legs removed leaving only the board. (I had this from work and was no longer using it so you could use something else.) Using the screws from the mount above can work but you need to file down the screws after mounting it to the board so they don’t affect your bedding or accidentally prick yourself with the point of a screw. Should probably be hand tightened and it will take a good bit to get through the board. Additionally, check the top of the hand-tightened screws, there could be some sharp points there that need to filed down as well.
Use the official theHandy mount with the projector mount, take a white t-shirt and cover the base section to ensure easy cleanup, place in between your legs where you’re pretty much sitting on it and lay down.
Bodyweight keeps the board in place, you might need 1/4 inch extenders between the projector mount connection and theHandy mount itself, female/male connector if needed. Pillows help to further stabilize it along with a weighted blanket on top. I can layback and enjoy the scenes with this setup.