Joints on the SR6 don’t move anymore…

All the sudden the middle joint on the right, top one on the right side, and the two on the left side have completely stopped moving. I assume from the motors being bad or connectors being loose. I have had no issues with power, up until now.

Have you contacted the huilder?

Yup, but they haven’t even responded to any of my questions in the past week and a half.

Bummer… Who built it?

It sounds like the servos have died. You can try troubleshooting by removing the receiver and links to allow the arms to more freely. It’s very hard to troubleshoot when they’re connected since you can’t tell which ones are moving and which ones are being dragged.

After you determine which servos aren’t moving, you can carefully rearrange the plugs (temporarily), by plugging a non-moving servo into the place of one that is working. If the servo continues to not move, then you know you need to replace the servo. If it comes to life, you have a power delivery or logic board problem.

Very hard to provide more specific device not knowing how the unit was built, what kinda board, power bus, etc. Which is typically why the builder can provide the quickest and most accurate guidance.

Well they responded back said we could do an exchange. So I was gonna send my back and he would send me a new one. I bought it from that link that’s in my post “your hobbies customized llc”, and uhm all the sudden the site is totally different and I don’t know how I should contact him now.

edit: https://yourhobbiescustomized.com/?source=returnToStoreCta&syclid=d42e3ts0npac73fpito0 I didn’t realize I didn’t put the link to it, but this is what the site looks like now and I can keep contacting him anymore like was before the site changed

Well nothing is moving now besides that fan lmao. I don’t really have the time to continue messing with it because work and college.