Question about ScriptPlayer v1.2.1 Heatmap

Help
1

Not sure if this would be better posted in the SW category? Mods, if so please feel free to move or let me know and I will do so.

Anyhow, is there a way (other than hovering) to see the heatmap for loaded/playing script in SP? In both MFP and HandyControl the heatmap is fully visible. In SP I have not been able to configure it to do the same - I am only able to hover over the progress bar in which I see only a few seconds on either side of the pointer.

Any help, or clarification, would be much appreciated!

-Nylon

2

Do you have “Show Heat Map” checked in Settings → Debug?

image
image820×605 62.1 KB

3

OMG!! What an idiot I am!!!

No, I did not have it checked - and I was obviously hallucinating when I thought I went “line by line” through every setting . . . .

Thank you!!!

4

btw: If you are looking for a setting - you can just search via the textbox in the top left corner

5

Thank you for the tip!

I actually have another questions - is there a way to limit the range on the Handy? I tried the various Range settings but didn’t seem to have any effect.

6

You can decrease the stroke range by simply pressing the down button above the Wi-Fi/Bluetooth button. Press it repeatedly until the range is to your liking, press the up button to increase the range again.

This page shows you the stroke zone controls, which affect online mode too.
https://www.thehandy.com/how-to-use-handy-stroker/offline-mode/
The video shows stroke zone controls starting at 17 seconds in.

7

Well I’ll be damned . . . . I thought those controls only worked in manual mode - not online. I have always used the range controls in SLR or Handy Control to adjust the stroke. Having decided to switch to Script Player for my 2D content (in lieu of HC) I am still climbing the leaning curve.

Thank you again - your help is very much appreciated!