Guide of codeScripter's multi-axis scripts

Script Using Notes

1. Some videos will rise to the highest position at the end. Please prepare cleaning supplies such as towels to avoid staining your bed or chair.

2. When the penis slips out, you should move away your body immediately to prevent injury instead of pausing the video (especially when using VR equipment)

3. Pay attention to safety and enjoy.

HardWare Notes

1. If you find that the screws of OSR2 or SR6 are loose, please tighten them, especially the screws of the servo motor.

Device Support

Device Common Script Support Extra Script Support
SSR *.funscript -
OSR2 *.funscript
*.roll.funscript
-
OSR2+ *.funscript
*.roll.funscript
*.pitch.funscript
*.twist.funscript
*.valve.funscript(.suckManual.funscript)
SR6 *.funscript
*.roll.funscript
*.pitch.funscript
*.sway.funscript
*.surge.funscript
*.twist.funscript
*.valve.funscript(.suckManual.funscript)
  • T-Twist is an extra component for OSR2+ & SR6. At present, the twist axis is 270 degrees as the standard.
  • T-Valve is an extra component for OSR2+ & SR6. Currently only available on Fleshlight.

Testing

Device Basic Testing Usage Testing Sleeve Motor VR Headset
SSR NO NO -------- ----- -----
OSR2 NO NO -------- ----- -----
OSR2+ YES YES Fleshlight & Tomax Real Very Soft Digital Meta Quest3 & Pico4
SR6 YES YES Fleshlight & Tomax Real Very Soft Digital & Brushless Meta Quest3 & Pico4

The testing process will be conducted in two phases:

  1. Basic Testing: I will run the scripts to confirm synchronization.

  2. Usage Testing: Upon personal utilization of the script, should I encounter any shortcomings or elements that are suboptimal, I will consider revising and enhancing it accordingly.

Point Value

If I can see the whole dick in the video, then my points are very precise.

Output setting of L0 Axis(Up & Down) , Keep the scale and output of other axes at 100%

MultiFunPlayer:Please set the ouput limit of L0, For example, set ouput to 0%-73% or 13%-87%. Just make sure the output range is 73%.


XTPlayer:Please set the ouput limit of L0, For example, set ouput to 0%-73% or 13%-87%. Just make sure the output range is 73%.

Device Max Stroke Length
SSR 120mm
OSR2+ 136mm/150mm
SR6 120mm
3 Likes

Just FYI MFP does not load .suckManual at all.

It’s .valve for direct T-Valve position control aka A0, and .suck for automatic suck algorithm (script sets valve position on up stroke, automatic full open on down stroke) using T-Valve aka A1.

At that time, it was found that this issue might have occurred in earlier versions of MFP and under special circumstances.The earlier versions of MFP were already very useful, so I haven’t updated it all the time. Now I have updated to the latest version of MFP. After conducting multiple tests, this issue no longer exists. Thank you for your reminder.