So we all love the @Khrull firmware. Easy to flash, supports Wifi also easy set up, nice browser setup screen. Now with the new Plasmarobo SSR1PCB the startup with Hall sensor is quite unsexy as its an additional board and extra cables or pins that need to be soldered.
The startup sequence without the Hall is not nice however. After some tiny moves the motor goes down, tensions the belt and motor unnecessarily and then goes up 120mm. My idea would simply be to position the adapter as low as possible before you connect the power cable. The weight of the sleeve will pull it down anyway.
Khrull is not really amused to make a firmware version just for me which I can full yunderstand. I just think its not only me who would like the startup be simpler and faster without motor and belt stress.
Voices please.
I could be wrong, but aren’t you just describing the calibration thing on start up, that it does if haven’t entered the parameters? Its been a while since I used Khrulls firmware but think it had a “parameters known” check box, I’d always assumed that was for entering the ZeroElecAngle you’d put in the Tempest firmware to skip calibration.
Thanks for the idea. Tried a ZeroElecAngle of 0 but it still does the down movement and belt/motor tensioning downward first.