Clean way to separate from SR6?

Help
1

Apologies for the gross question, but I wanted to know if anyone had tips for cleanly pulling out from an SR6 after finishing? I use it while in a desk chair so it’s vertical with the aperture facing down, meaning when I pull out there can be drips. Is there a way anyone has devised to contain the mess while removing the sleeve from the twist ring and pulling out?

1 Like
2

Twist the sleeve holder to make it free to remove, then pull it straight up and turn it sideways as soon as it clears your permanently attached equipment. If you do it right, there’s no mess. Just be prepared to do it wrong a few times before you figure it out.

Alternately, have a few paper towels wadded up and ready to place in the way immediately to avoid having to master the fast rotation to horizontal.

1 Like
3

I use an onahole so it goes about:

  1. Power off the servos
  2. Release the velcros, remove the onahole from below.
  3. Pull myself out.

If you use a fleshlight you may be able to remove the sleeve the same way. Just keep the plastic cup mounted.

1 Like
4

While still inside I would squeeze at the base and pull the whole sleeve out of case/strap.

1 Like
5

I 3D printed a new twist receiver for my SR6 for the Kiiroo case, it attaches from the bottom instead of the top like a fleshlight case - SR6 Twist Kiiroo Adapter by DarkStorm00777 - Thingiverse

1 Like
6

With a fleshlight I grab the cap and slip it under as I pull myself out, then wait for some of it to drip down into the cap, then I can lift it up without making a mess. Never had and issue doing that.

I also have a towel on the chair in case anything does get out.

7

Condoms would also do the job, if you are willing to use them for this.

8

Hello after buying a pre-built SR6 with Twist from yourhobbiescustomized I also had both of these adapters printed off by an online service. The adapters click together and connect onto my Kiiroo case, I’m just unsure now how it inserts into the SR6?

Do I need to unscrew the twist gear that’s already installed on the SR6 and replace it with the adapter?

Thanks

9

Hey yeah you need to replace the original holder/receiver with the gear with this one by removing the screws around the twist receiver

Also a tip is to put a little super glue where the 2 halves join because it can unclip and come out and it’s annoying.

1 Like