this is basically a tutorial to turn your handy into an awesome fucking machine.
3D Print Model Handy Dildo Adapter
How to choose a dildo
Choose a medium or small one, not very thick between 2.5 cm and 4 cm, as light as possible, without balls or unnecessary extra weight. preferably less than 200 grams.
one that you can take easy, it has to be long enough to stay inside all the time. if it comes out at some point the handy might not have the strength to shove it inside and the safety brake will appear.
for example:
get a long double dildo and cut it to 2/3 of its length and grab the cut part to the handy strap.
another option is to take a small bottle, adjust it to the strap, and put the dildo on the tip, removing the suction cup
How to setup the Handy
Matireals:
- Good quality Wide Pintor Tape (3M like). try not to use duct or transparent tape, will let some glue in your handy.
- 50CM wood or metallic Ruler
- nightstand, chest of drawers, bookcase or door frame
Put the painter’s tape on each side of the ruler, leaving more than half the tape on the outside. As seen in the image
tape the ruler to the Handy on the side opposite the power input, check the tip of the ruler reaches the base of the Handy but does not exceed it, and make a cut in the tape right at the top of the handy
Now you can tape the other half of the ruler on a nightstand, dresser, bookcase, or door frame. make sure that the tip of the handy is in contact with the nightstand and put an extra tape as you see in the picture. this will prevent it from swinging
check it is above the chair or bed where you are going to be it is important to be relaxed and in a well-aligned position.
You can gently remove it and stick it back in another position or location. you can do this a few times until the tape loses the adhesive.
The dildo must be below or to the side of the handy, but never above as fluids or lubricant could fall inside it.