Just curious to know what everyone’s cleaning routine is. Personally, when I’m cleaning, my FL/onahole I typically dry off with towel and let it air dry and sometimes use 70% isopropyl alcohol. I’ve been looking into UV sterilization as well and can’t seem to find a decent one.
Curious to know if there are any DIY suggestions for UV sterilization and warming up sleeves.
…i use a small air pump, for an aquarium, and a length of airline. Push the airline down to the base of the sleeve and leave running a few hours, the constant flow of fresh oxygenated air will both dry it out, and prevent the formation of those pesky, stinky old anaerobic bacteria.
It’s an old skool technique for sex dolls, where it’s literally impossible to invert the poor dear like a sleeve, and constant rough unlubricated (dry) towelling would damage the internals of what is essentially a very valuable sex toy.
[Cite: i’ve at least one doll that i’ve used this technique with for years, and never had an issue with bad bacteria in all that time.]
i warm up sleeves by filling a sink with hot water and leaving them in there for a few mins…
1 Like
Appreciate the feedback. I had a small pc fan that had an adapter that went into the sleeve but would eventually develops an odor so I’d get rid of them. I have to give your way a shot