Post processing for OFS MTFG usecase - too fast quickfix

Recommended max stroke speed is 600U/sec.

image

This speed is too fast if max speed in OFS is set to 600U/sec, the exceeding speeds will be shown in lilac. It would take a lot of work to correct all points to red. There is a very fast way to get them to usable maximum possible speeds.

Install MTFG and @quickfix LUA extension.

image

Mark the area you can also mark sub 600U/sec areas they wont be touched.

image

image

Choose if you want to move the lower or upper points with select peaks.

image

image

Press LIM. Done.
(Sometimes there is a peak or two that are too narrow that you need to adjust manually but works 99%)

3 Likes